Moderator: Moderators
kingofthespill wrote:Too hypertensive
There are gaps in the sheets, I just didn't put any between the bars - probably because it was never a problem before, but you're right that I should have done so. Sorry for that.dudiobugtron wrote:Keep small gaps between longer runs of iron. This will detach them and prevent most problems with strangely interacting solutions.
PeterT wrote:I probably should have just used some l33t .lvl haxxoring to put a single metal bar/sheet all across the center
PeterT wrote:There are gaps in the sheets, I just didn't put any between the bars - probably because it was never a problem before, but you're right that I should have done so. Sorry for that.dudiobugtron wrote:Keep small gaps between longer runs of iron. This will detach them and prevent most problems with strangely interacting solutions.
Anyway, just think of it as a small punishment for using the anchor points in the center instead of those on the upper and lower border
I probably should have just used some l33t .lvl haxxoring to put a single metal bar/sheet all across the center
BFC wrote:Don't feel too safe Orjan
-BFC
Malco wrote:I cant get these pink unicorns to do anything for me...
Users browsing this forum: No registered users and 17 guests