Page 2 of 2

PostPosted: Thu Sep 20, 2007 9:10 pm
by smjjames
I'm confused. don't you mean left? because the right part goes down. I understand the whole fulcrum and lever setup though.

edit: where did that pic go? it was here a minute ago. Unless somehow the post was put in here, wierd.

PostPosted: Thu Sep 20, 2007 9:14 pm
by FF
Sorry, that was wrong picture :)
Here is correct one.
This are the things going on in the Real world. In unw's solution Right body goes up.

PostPosted: Thu Sep 20, 2007 9:19 pm
by smjjames
The right body (assuming you mean the arm) still goes down in unw's level, I'm still a bit confused what you mean there. Then again, I suck at math.

unless you mean weightwise, since the left part is heavier, that one should go down.

PostPosted: Thu Sep 20, 2007 9:26 pm
by gamma57
Conservation of Angular Momentum ftw!

you proved that there was an outside torque applied to the system! yay. 8)

PostPosted: Thu Sep 20, 2007 9:30 pm
by FF
This was just a sketch.

In unw's solution:

ON THE LEFT SIDE:
Ball+Part of construction.
ON THE RIGHT SIDE:
Another part of construction.

I just want to say that LEFT (Mass*Length) > RIGHT (Mass*Lenghth).

So armadillo must go down.

As it is not happening, solution is dark.

EDIT:
gamma57 wrote:Conservation of Angular Momentum ftw!

you proved that there was an outside torque applied to the system! yay. 8)

YEEES!

PostPosted: Thu Sep 20, 2007 9:39 pm
by smjjames
yea, like I said, it is impossible unless the material on the right actually was heavier (although angular momentum would still affect it) or it was bieng physically pulled down as in a winch.

PostPosted: Thu Sep 20, 2007 11:55 pm
by TSchultz
Do you mean torque not angular momentum? Torque is the thing that makes things rotate.

PostPosted: Fri Sep 21, 2007 12:45 am
by JustcallmeDrago
Unw you should've just put another metal bar on the right side so no one would've noticed and you still would've won.

PostPosted: Fri Sep 21, 2007 9:22 am
by Cresta
ok so, stop!

:lms: to FF
:dms: to unw

and new level come on!