Armadillo Run forum

Time is up, here are the results

4th place 1095 votart. I'm used to seeing you in the top2 Still 3 very nice solutions

3th place 1106 mi2. A lot like votarts but a cheaper catcher. I like your clueless solution

2nd place 1112 njaa. Looks like you are not very rusty at all, nice to see you found the trick with that right-top cloth.

1st place 1146 markmadras Abusing a bouncebug but still a very nice solution. 2nd solution is good too, 1114 without abuse Congrats

Also included my POC and a catchertweak to marks winning solution
Thanks for playing and see you in the next contest.

nice sec place njaa. well done mark. i cant say something more

Nice solutions guys. I looked at this level a little, but never really came up with any good solutions.

Good solutions markmadras, but in 1146 such long metal sheet below is impossible How

Sorry for delay, my internet has been off, and thanks for all the compliments . New contest starting soon.

Votart, the metal plate at the base was not a trick and was put in place the normal way

Votart Silak wrote::?:

You said the metal sheet is impossible, but it is possible

If you draw a metal plate between the anchors it will split into two before making a connection with the other anchor, but, if you stop stretching out the plate before it splits into two and then go back and continue stretching it, it will reach the other anchor simple

My internet connection is still coming and going but will try to get new contest on ASAP.

markmadras wrote:

Votart Silak wrote::?:

You said the metal sheet is impossible, but it is possible

If you draw a metal plate between the anchors it will split into two before making a connection with the other anchor, but, if you stop stretching out the plate before it splits into two and then go back and continue stretching it, it will reach the other anchor simple

My internet connection is still coming and going but will try to get new contest on ASAP.

hmm i cant get it to work!. anyone else got this prob ?

Have a go at the solution I did, delete the plate and try to re-draw it. If you or other players can't make it connect then Peter should be told about the problem, it is very strange

If you create a plate from A to B it divides into 2 plates. You have to create a plate from A to a random point. Shift-select the loose endpoint, release shift, move towards B until it snaps and then release the mousebutton. Voilla
I do think this is a bit of a bug in the editor...

wow i think i never recognized this ever before. it worked now but never used that trick before

rob wrote:If you create a plate from A to B it divides into 2 plates. You have to create a plate from A to a random point. Shift-select the loose endpoint, release shift, move towards B until it snaps and then release the mousebutton. Voilla
I do think this is a bit of a bug in the editor...

Now, at me it has turned out. Thanks!